Appro WH300 Guida Utente Scaricare il pdf (Pagina 15)

Rev. 2.0

1/23/06

Appro WH300 User’s Guide 14

4. Line up holes in floppy drive with holes in chassis (letter D in the figure). Move latch to

the “lock” position (letter E).

5. Connect power (P5 connector from power supply) and data cables to the rear of the floppy

drive (letter F in the figure below).

3.7 Peripheral Drives

3.7.1 Device Installation Considerations

The number of devices you can install depends on:

 The number supported by the bus on your server board and/or add-on controller

card

 The number of physical drive bays available

 The combination of SCSI and IDE devices

 The amount of power required by other components in your workstation.

3.7.2 IDE Requirements

If no drives are present on an IDE channel, the cable must be removed. If only one

drive is installed, it should be connected at the end of the cable.



NOTE

To disable the IDE controller: If you plan to disable the

IDE controller to reuse the interrupt for that controller, you

must physically unplug the IDE cable from the board

connector if a cable is present. Simply disabling the drive

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 36 37

Nessun commento

Appro WH300 Guida Utente Pagina 15